Your garage door panels may be damaged or dented through misuse or they might be tired and old after being used for many years. Whatever the reason it is important that you replace panels for your door’s functionality to be improved. Always make sure that you buy the right ones. Also, check the model and the make of the existing door because even if it looks similar it may not fit well if the wrong type is chosen.
Ideally, garage door panels make the better part of a garage door. Since they compose of the main door, you should always check whether you are working well. Remember, there are different types of panels including roller garage doors, slide up, sectional and single paneled garage doors. Because each type has a different number finding a replacement might prove tricky depending on how you want to go about it, so it would be wise to hire Garage Door Dented Panel Repair Simi Valley.
Measure the panels
Returning a wrong panel is another difficult task. In order to avoid this mistake measure your garage door panels and ensure that you are 100% accurate before ordering anything. You should compare the width and the length of your measurements with the size of your other panels. Once you are done with all the measurements you can go ahead and order.
Order the panels
Establish who manufactured your garage door before you order. If your garage door is much older it is in order to contact the manufacturer directly. Otherwise, ensure that you order the correct number of garage door panels. You can easily do this through a local company that sells them.
Remove the panels
Before doing this, ensure that your automatic garage door opener is unplugged if you have on fitted. Next, open the garage manually and remove the springs. If you fail to do this there are high chances that the door could burst open while working on it which could injure you or damage the new ones. Remember, you are going to have to remove it one by one unless they are at the top.
Replace the panels
To put in the new panels, slide the rollers and lower them until they are touching them. These will still be in place on the garage door. Next, attach both the new and the old panels together. This depends on the existing fastening. Reattach all the panels the way they were until the door is back in place. Finally, test the garage door by using the opener to check if the panels are sliding up and down smoothly.
Remember, replacing your garage door panels can be a very hard task if you do not follow the correct procedure. Essentially, measure your panels to ensure that they will fit well. If you are not sure, contact an expert.
Garage Door Repair Simi Valley have been affordable garage door repair company in Simi Valley for several years with high standards.